Table of Contents
Advertisement
3.2
Removing the cover
It's not necessary to remove the re-sync unit first. The re-sync unit is attached to the cover and comes off
with the cover.
Necessary tools
•
Torx T20.
•
7 mm nut driver.
How to remove the cover ?
1. Release the six screws (P) of the ILite cover (L), one in each corner and one under each handle.
F
Image 3-1
2. Remove the cover from the rest of the tile (L).
R5976460 ILITE LED REPLACEMENT KIT 29/03/2007
3. Replacing a bad LED from an ILite LED board
L
P
13
Advertisement
Table of Contents
