Sony DSC-QX10 Service Manual page 27

Installation
1. Install the LF-139 Flexible Board to the DC Motor Worm Assy and solder the LF-139 Flexible Board at two locations.
2. Install the DC Motor Worm Assy to the Stationary Tube Assy with two screws.
3. Install the Gear Worm Wheel, Gear A, and Gear B.
4. Install the Rear Mirror Plate.
DC Motor Worm Assy
Screws
5. Install four screws and the Z Retainer. Tighten the screws in the order of numbers in the figure below.
6. Install the LF-139 Flexible Board.
Screws
4
2
7. Connect the two Flexible Boards to the Connectors on the LF-139 Flexible Board.
8. Stick the FPC Tape as shown in the figure below.
9. Install the two Sensors and attach the FG Leaf Spring.
Note: Attach the FG Leaf Spring in the correct orientation.
10. Attach the FPC Retainer.
Flexible Board
Connector
DSC-QX10
Solders
LF-139 Flexible Board
Z Retainer
Screw
3
1
Sensor
Connector
Flexible Board
FPC Tape
FPC Tape
Gear B
Gear A
Gear Worm
Wheel
LF-139 Flexible Board
Ribs
Boss
Rib
Draw up
FPC Retainer
Rib
4-9
Rear Mirror
Plate
Boss
Boss
Rib
Boss
Claws
FG Leaf
Spring
Sensors
OK
Claw
FG Leaf Spring
NG
FG Leaf Spring
Rib
Fold inside