Sony DSC-QX10 Service Manual page 26

(2) DC Motor Worm Assy Replacing Method
Removal
1. Disengage the two claws and remove the FG Leaf Spring.
2. Remove the two Sensors.
3. Disengage the claw and remove the FPC Retainer.
4. Disconnect the two flexible boards from the connectors on the LF-139 Flexible Board.
5. Peel off the FPC Tape.
Claw
FPC Retainer
6. Remove the LF-139 Flexible Board.
7. Remove the four screws and remove the Z Retainer and the Sensor.
LF-139 Flexible Board
Boss
Ribs
Boss
Rib
8. Detach the Rear Mirror Plate and remove the Gear Worm Wheel, Gear A, and Gear B.
9. Remove the two screws and remove solder at two locations to detach the DC Motor Worm Assy.
Gear B
Gear A
Gear Worm
Wheel
DSC-QX10
Claws
FG Leaf
Spring
Sensors
Rib
Boss
Rib
Boss
Rear Mirror
Plate
Flexible board
Connector
Z Retainer
Screws
DC Motor Worm Assy
Screws
4-8
Connector
Flexible board
FPC Tape
Screw
Sensor
Solders
LF-139 Flexible Board