Power Saving Function; Displaying The Information Osd; Plug & Play - Sony CPD-L133 Operating Instructions Manual

Power Saving Function

This monitor meets the power-saving guidelines set by
E S
VESA and NERGY TAR, as well as the more stringent
NUTEK .
If the monitor is connected to a computer or video graphics
board that is VESA DPMS (Display Power Management
Signaling) compliant, the monitor will automatically reduce
power consumption in three stages as shown below.
Power consumption Screen
mode
1 Normal operation active
2 Standby (1st mode) blank
3 Suspend (2nd mode) blank
4 Active-off (3rd mode) blank
5 Power-off ––
* Power consumption of the monitor only
** Power consumption of the monitor including the AC adaptor
Displaying the INFORMATION
OSD
You can confirm the name, the serial number and the year
of manufacture of this monitor.
Press and hold the MENU button for five seconds.
The INFORMATION OSD appears.
MENU
Example
INFORMATION
MODEL : CPD-L150
SER. NO : 1234567
MANUFACTURED : 1998
The INFORMATION OSD automatically disappears after
about 30 seconds.
To close the OSD, press the MENU button again.
Horizontal Vertical Power consumption
sync signal sync signal
present present CPD-L133
CPD-L150
absent present CPD-L133
CPD-L150
present absent CPD-L133
CPD-L150
absent absent CPD-L133
CPD-L150
–– –– CPD-L133
CPD-L150
Model name
Serial number
Year of manufacture
Getting Started
You can set the delay time before the monitor enters the
power saving mode using the OSD. Set the time according
to "Setting the Power Saving Delay Time" on page 14.
Note
If no video signal is input to the monitor, the "NO INPUT
SIGNAL" message (page 18) appears. After the delay time has
passed, the power saving function automatically puts the monitor
into the active-off mode and the u indicator lights up orange. Once
the horizontal and vertical sync signals are detected, the monitor
automatically resumes its normal operation mode.
Recovery time
30 W* 42 W** —
25 W* 35 W**
1.5 W* 4 W** Approx. 3 sec.
1.5 W* 4 W**
1.5 W* 4 W** Approx. 3 sec.
1.5 W* 4 W**
1.5 W* 4 W** Approx. 10 sec.
1.5 W* 4 W**
1.5 W* 4 W** —
1.5 W* 4 W**
Plug & Play
This monitor complies with the DDC 1 and DDC2B
Display Data Channel (DDC) standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
DDC is a trademark of the Video Electronics Standard
Association.
Technical Features
u Indicator
Green
Green and orange
alternate
Green and orange
alternate
Orange
Off
17
EN
F
D
ES
I