Advertisement
Quick Links
Advertisement
Related Manuals for Pergola kits USA Sunbrella Side Shade
Summary of Contents for Pergola kits USA Sunbrella Side Shade
- Page 1 Sunbrella Side Shade Assembly Manual...
- Page 2 Cable Mounting 3.1/2’’ Lag Bolt I-Hooks Cable Clamps Bracket w/ Washers Mounting Block 3” Brown Screw 2’’ Pan Head Screw Curtain Assembly Control Rod Includes Fabric and Curtain Cover. Tools you need but not included. 1/4’’ Drill Bit Dikes Wrench with 9/16 Wrench Vice Grip (2) 6’...
- Page 3 The instructions in this manual show installing the curtain on a cedar pavilion. Before starting, read through the entire manual. See the next 3 pages for the different ways of mounting to different structures then follow the rest of the manual for complete installation instructions.
- Page 4 Wood Traditional Roof Pavilion Place the blocks on the Curtain Box up against the Top Plate of the Pavilion and in against the Post Trim. Fasten with 3/8” Lags. Rough Sawn Cedar Pergola If installing on the side with the Rafter overhang, install the double 2x6 Block between the first two Rafters at each end.
- Page 5 Classic/Serenity Pergolas If installing on the side with the Rafter overhang, install the 2x6 Block at each end. Place on top of the Top Plate and against the Rafter. Place the short ply of the Block against the end of the Top Plate. Fasten with Timber Lock Screws through pre-drilled holes.
- Page 6 Begin by placing the Curtain Assembly close Carefully remove protective shrink wrap from to the project site. the Curtain Assembly and remove all parts. This is for Alpine Pavilions only. Locate Fasten Mounting Blocks to the Rafter using Mounting Blocks and place the Blocks on the 3’’...
- Page 7 Lift the Curtain Assembly into place. Ensure the Gear Handle and Cable are pointing down. Center Curtain Assembly to Pavilion. Using 1/4’’ Drill Bit, pre-drill through the Mounting Bracket into the Mounting Block approximately 3 1/2’’. Fasten opposite side using previous steps. Fasten using (2) 3 1/2’’...
- Page 8 Using a 6” drive bit, install the screw in the Lower the Curtain to the lowest point that you center area up into the Block or Top Plate. want the curtain to be. Install one screw in the (Depending on the type of structure.) center area of the Curtain Box.
- Page 9 Locate the I-Hook. Place the I- Hook through the Cable Mounting Bracket and turn the nut onto the bolt just so it is started. Locate the Cable Clamp and slide the cable Run the cable through the I hook. through the clamp. Then run the end of the cable back through the Pull the cable tight and push the Cable Clamp Cable Clamp.
- Page 10 Install opposite side using previous steps. Note: do not over-tighten the cable. The cable can have a little play. Pergola Kits USA Customer Support: (800) 403-9259 Fasten End Caps using 2’’ Pan Head Screws through all pre drilled holes. Enjoy your new Sunbrella Side Shade!