Related Manuals for PV Electronics WiFi NTP Sync Device
Summary of Contents for PV Electronics WiFi NTP Sync Device
- Page 1 WiFi NTP Sync Device For Nixie Clock NTP Sync Device - 1 - Issue 2 (01 June 2022) www.pvelectronics.co.uk...
-
Page 2: Standard Features
For use indoors only Introduction: The WiFi NTP Sync Device provides a convenient and low cost method to synchronise time and date on our compatible Nixie Clocks. Summary of Operation On a factory power up, the device sets up in Access Point (AP) Mode. - Page 3 Assembly Check you have all the parts shown above, and then peel off the protective film from the laser-cut support piece; Note that the film may be blue, green white, or even clear, but there is a film on both sides that needs to be peeled off. Soldering the Jack Socket.
- Page 4 Then place the connector in position and re-touch the pad with the soldering iron whilst pressing the connector onto the PCB. This will anchor the component and then you can solder the remaining pads. Soldering the 4X2 Header. Solder the 6X2 female header as shown in the picture below.
- Page 5 Place the plexi support in the cutout slot on the circuit board. Push the ESP module into place in the 4X2 header and it should sit in the recess of the plexi support. NTP Sync Device - 5 - Issue 2 (01 June 2022) www.pvelectronics.co.uk...
-
Page 6: Configure Device
Setup Guide: 1. Configure Clock Setup the clock for GPS reception at 9,600 bps. Don't forget to set your local offset from GMT (UTC). 2. Connect Always connect and disconnect whilst the clock is powered off. Insert the cable into the back of the clock, and the other end of the cable into the NTP Sync Device. - Page 7 Now follow the steps carefully below, using a smartphone or computer 1. Open up the Network 2. Connect to NixieAP 3. You may or WiFi settings on your You may get warnings automatically get the phone and look for the on your device that landing page.
- Page 8 You are now back at the landing page. Click Exit Portal. You must do this, to save the settings. IMPORTANT: Now click 'Exit Portal' to save the settings. The NTP Sync Device will reboot and attempt to connect to your WiFi. Status Indicator LEDs: WIFI Steady: The module is connected to your WiFi Router...