Hooking Up The Audio Components - Sony MDS-E12 Operating Instructions Manual

Hooking Up the Audio
Components
Hook up a mixer, CD player, DAT recorder, and other
components to the MD recorder. Be sure to turn off the
power of each component to do so.
R IN L R OUT L ANALOG DIGITAL
PUSH PUSH
INPUT
L IN
LEVEL
OUTPUT
LEVEL IN OUT 5
+4dBu -10dBu
R OUT
0 10
COAXIAL
ANALOG(BAL) ANALOG(UNBAL)
Remote or
control
component
External
control
component
MDS-E12
External
control component
DIGITAL
OUT IN
COAXILAL OUT
Mixer
OUT IN
Mixer
ç : Flow of signal
z When the remote is used as the wired remote
Use the supplied control S cable to connect the jack at
the front of the remote with the control jack of the
recorder.
When the recorder and remote are connected by the
control S cable, infrared rays are not emitted from the
remote and infrared rays are not received by the
recorder.
When the remote is used as the wireless remote,
unplug from the jacks of the recorder and remote.
CTRL-S
PARALLEL RELAY RS-232C
230V
IN OUT IN
120V
VOLTAGE
REMOTE SELECTOR
To power outlet
DIGITAL
COAXILAL IN
CD player or
DAT recorder,
MD recorder
1 Prepare necessary connecting cables.
• Audio connecting cable (pin type)
White
Left (L)
Right (R)
Red
• Audio connecting cable (XLR type)
• Coaxial digital connecting cable VMC-10
• Control-S cable (accessory)
(Mini-jack)
• Relay record/play cable (RK-G136)
(Stereo-Mini-jack type)
2 Connect.
xWhen connecting with analog components
Use the connectors and switch in the figure below.
ANALOG BLANCE ANALOG UNBLANCE
I/O terminal
R IN L R OUT L ANALOG DIGITAL
PUSH PUSH
INPUT
L IN
LEVEL
OUTPUT
LEVEL IN OUT 5
+4dBu -10dBu
R OUT
0 10
COAXIAL
ANALOG(BAL) ANALOG(UNBAL)
OUTPUT LEVEL
selector
Change the INPUT selector on the front panel depending
on the type of the input connector to be used.
Connector to which the
program source is
connected
UNBAL IN
(pin type)
BAL IN
(XLR type)
z A signal is output to both the UNBAL and BAL output
terminals regardless of the setting of the INPUT switch
z When the BALANC output (XLR type) terminals is used, the
output level can be changed by the OUTPUT LEVEL selector
White
Left (L)
Right (R)
Red
(Stereo-Mini-jack type)
I/O terminal
CTRL-S
PARALLEL RELAY RS-232C
230V
IN OUT IN
120V
VOLTAGE
REMOTE SELECTOR
Position to adjust the INPUT
selector
UNBAL
BAL
15