Installation Location; Indoor Unit; Outdoor Unit; Installation - Trane R-410A Installer Manual

Installation Location

Indoor Unit

Adequate Support!
Wall structure must be adequate to support the weight of the unit. Failure to ensure
adequate structural support could result in unit falling from its location which could
result in death, serious injury, or equipment or property-only damage.
1. The air inlet and outlet should be far away from anything that could prevent the air from
2. Select a location where it is easy to drain the condensing water and connect to the outdoor unit.
3. Keep the indoor unit far away from heat sources, vapor and inflammable gas.
4. Be sure that the installation of the indoor unit conforms to the installation dimension diagram.
5. Be sure to leave enough space to allow access for routine maintenance; clearance between the
6. Install in a location where the unit is more than 3 feet away from other electric appliances such
7. Select location where air filters can be easily removed.

Outdoor Unit

Adequate Support!
Wall structure must be adequate to support the weight of the unit. Failure to ensure
adequate structural support could result in unit falling from its location which could
result in death, serious injury, or equipment or property-only damage.
1. Select a location from which noise and air discharge by unit will not annoy neighbors.
2. Select a location where there is sufficient ventilation.
3. Make sure the air inlet and outlet are not blocked by any obstacles.
4. Select a location capable of supporting the weight and vibration of the outdoor unit, and where
5. Select a location away from flammable gas or gas leaks.
6. Make sure that the installation of the outdoor unit conforms to the installation dimension
NOTICE
•
•
•
•
•
•
MS-SVN055B-EN
WARNING
reaching all parts of the room.
indoor unit and the floor should be more than 7 feet.
as television, audio devices etc.
WARNING
installation work can be carried out safely.
diagram.
Installing the unit in one of the following locations could result in unit malfunction:
Places where oil (machine oil) is used
Seaside/places with high level of salt in the air.
Places with high level of sulfur gas such as areas with hot springs.
Places where high-frequency waves are generated by radio equipment, welders and medical
equipment.
Other unusual places where unit operation may be altered.

Installation

9