Parameters can be checked in the following table below.
Parameter
code
P.0
Fault codes
P.1
Compressor actual frequency
P.2
Compressor driving frequency
P.4
Compressor target frequency
P.5
Compressor exhaust temperature
P.6
Outdoor suction temperature
P.7
Outdoor ambient temperature
P.8
Outdoor coil temperature
P.9
Outdoor defrosting temperature
P.10
IPM module temperature
P.11
Outdoor capacity requirement
P.13
Outdoor DC Motor target speed
P.14
AC input current
P.15
AC input voltage
P.16
DC bus voltage
P.17
Compressor phase current
P.18
Frequency limit code
P.20
Target suction overheating
P.21
Target exhaust overheating
P.22
Actual suction overheating (heating)
P.23
Actual exhaust overheating (heating)
NOTE: The right is therefore reserved to EE changing without notice.
Descriptions
- 24 -