Camozzi 50 Series Mounting Instructions page 2

Series 50 rodless cylinders
Brackets mounting instructions
Foot Bracket kit Mod. B-50-Ø...
1. To properly fasten the brackets to the
cylinder, hold the nut on the opposite end
of the cylinder to prevent rotation.
2. Secure the bracket with the screws
supplied using the required torque from
the chart below for the corresponding
model. If the screw is over torqued the
cylinder may not function properly.
Bore
Mod.
(mm)
16 B-50-16
25 B-50-25
32 B-50-32
40 B-50-40
50 B-50-50
63 B-50-63
80 B-50-80
Support block kit Mod. BH-50-Ø...
1. Insert the clamp block into the dovetail
slot.
2. Secure the brackets into the appropriate
location (fasteners for securing the
brackets are not included).
3. Slide the clamp block along the tube and
line up the counterbore with the threaded
hole of the brackets.
4. Insert and tighten the screw into the
threaded hole to hold the cylinder firmly
in place.
Self-compensating adaptor Mod. CF-50-Ø...
1. Insert the transfer pin into the hole in the
carriage.
2. Using two flat head cap screws, fasten the
self-compensating adaptor to the desired
side (fasteners for securing the brackets
are not included).
3. Align the flat sides of the transfer pin with
the slot in the bracket. Slide the cylinder
with the pin aligned into the slot in the
self-compensating adaptor.
Camozzi Automation spa
Società Unipersonale
Via Eritrea, 20/I - 25126 Brescia - Italy
Tel. +39 030 37921 - Fax +39 030 2400430
info@camozzi.com
www.camozzi.com
Required torque
(Nm)
2
3
3 Screw
3
5
5
5
Technical assistance
Product inquiries and
requests for support
Tel. +39 030 3792790
service@camozzi.com
Foot
bracket
Self-compensating
adaptor
Screw
Clamp block
Brackets
Product Certification
Information concerning
product certifications, EC standards,
conformity declarations and instructions
productcertification@camozzi.com
Transfer pin