Maintenance Tips; In Case Of Malfunctioning - ProMed 5040-SX2 Instruction Leaflet

Manicure and pedicure care unit

Table of Contents

Available languages

aIntenanCe tIPS

• Use only cutters which correspond to the standardized Dental

diameter (Ø 2.332 mm to 2.350 mm)!

• Never use cutters which are deformed damaged or are not

concentric. We recommend the use of cutters with a maximum

head diameter of 13 mm.

• Always adhere to the abrasive product recommendation

(milling head diameter – recommended speed) of the device.

• At higher revolutions the run becomes irregular (vibrations in the

handpiece), so the chuck, the ball bearings and the cutters can

be damaged.

• When in doubt for the speed information, always comply with

the speed given by the manufacturer.

Q. By pressing the operating hours indicator button (J), the

total operating time of the device is shown on the display. To

deactivate this display option, you must press the operating

hours indicator button (J) again.

Note: As long as this information is displayed, all

functions are deactivated and the device does not react to

any other push of a button.

• Check for the correct power supply.

• Make sure the unit is turned on.

• Check that the foot pedal is connected to the device correctly.

• If the problem is still not fixed, contact immediately to your service

center.

Kaitstud / Secured by https://mereneid.eu/

Table of Contents