Page 1
Apollo Quick Start Guide Use of the L&M hardware and software products indicate acceptance of the terms and conditions found here: https://landminstruments.com/legal/ Rear View Apollo Detail Font View Optical Intake Start/Stop Button Battery Access Not a dial % of Target...
Page 2
In this mode, a custom USB cable (APOLLO-LP-2-CBL-01) is used to connect Apollo to a Windows PC. In this mode, the Apollo device is controlled by the Apollo app running on the PC. The Apollo app will present one or more tabs, with each tab providing additional functionality as described below.
Page 3
Apollo Quick Start Guide Installing the Apollo App for Computer-Controlled Mode 1) Attach Apollo to a Windows PC, using the Apollo-LP-2-CBL-01 as indicated below. Note that the cable is reversible at the Apollo end. Apollo-LP-2-CBL-01 Windows PC Apollo 2) Download the Apollo app from the Apollo Downloads tab found here: Support | (landminstruments.com).
Target (100%) Dose above the dose being collected; (2) with Apollo disconnected from the computer press the Start/Stop button; (3) place Apollo in the area of interest for dose collection; (4) press the Start/Stop button when dose is complete; (5) attach to the computer and, from the Info tab, select “Reload from Device”...
While the Apollo device is sampling the light at several kilohertz, the Meter tab will request an update on all presented data, from the device, at an interval of approximately 5 seconds.
Page 7
Apollo Quick Start Guide The “Meter” Tab 1) Your Apollo application may present a “Meter” tab. This tab can be used to monitor, chart and record both the dose and irradiance over time. WARNING: Do not use the Start/Stop button on the Apollo device when using this feature. Use the on- screen Apollo app controls to interact with the Apollo device.