Troubleshooting - Hyundai HYURSD086GW8AF Instruction Manual

5. TROUBLESHOOTING

Before troubleshooting, disconnect the power supply. Only a qualified electrician
of competent person must do the troubleshooting that is not in this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
The food is too warm.
Appliance cools too
much
Unusual noises
Side panel is hot
CAUTION!
IMPORTANT!
These sounds are not a reason for complaint!
Possible cause
Temperature regulation knob
is set at number "OFF".
Mains plug is not plugged in or
is loose.
Fuse has blown or is defective
(circuit breaker is OFF).
Socket is defective
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Condenser is inside the panel.
EN - 45
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary (switch ON the
circuit breaker).
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the installation
location section.
Turn the temperature
regulation knob to a warmer
setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
It's normal.
EN