Leveling The Unit; Space Requirement - Hyundai HYURSD086GW8AF Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 33
4. INSTRUCTIONS FOR USE

Leveling the unit

▪ To do this adjust the two leveling feet at front of the unit.
▪ If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Note: Above pictures are for reference only.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance. For refrigerating appliances
with climate class:
- extended temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 10 °C to 32 °C (SN)
- temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C (N)
- subtropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C (ST)
- tropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C (T)
Location
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabi-net and the wall unit must be at
least 100 mm. Ideally, however, the appliance should not be positioned below overhanging
wall units. Accurate leveling is ensured by one or more adjust-able feet at the base of the
cabinet. This refrigerating appliance is not intended to be used as a built-in appliance.
First use / cleaning the interior
Before using the appliance for the first time, wash the interior and all internal
accessories with lukewarm water and some neutral soap so as to remove the typical
smell of a brand new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these will damage the finish.

Space Requirement

▪ Keep enough space of door open.
▪ Keep at least 100mm gap at two sides.
IMPORTANT!
EN - 41
EN
915 mm

Advertisement

Table of Contents
loading

Table of Contents