Hitachi Virtual Storage Platform G1000 Hardware Manual page 152

Item
Dust
Notes:
1. Environmental specification for operation should be met before the storage system is powered on. Maximum
temperature of 90°F/32°C at air system air inlet should be strictly met.
2. Unless otherwise specified, the non-operating condition includes both packing and unpacking conditions.
3. The system and components are packed in factory packing for shipping and storing.
4. No condensation in and around the drives should be observed under any conditions.
5. Vibration specifications are applied to all three axes.
6. See ASTM D999-01, Standard Test Methods for Vibration Testing of Shipping Containers.
7. See ASTM D4728-01 Standard Test Methods for Random Vibration Testing of Shipping Containers.
8. See ASTM D5277-92 Standard Test Methods for Performing Programmed Horizontal Impacts Using an Inclined
Impact Tester.
9. See ASTM D6055-96 Standard Test Methods for Mechanical Handling of Unitized Loads and Large Shipping
Cases and Crates.
10. Applies only when flash module drives are installed.
11. See ANSI/ISA-71.04-2013 Environmental Conditions for Process Measurement and Control Systems: Airborne
Contaminants.
The following table lists the maximum acoustic emission values [loudness in
dB(A)] for the VSP G1000, VSP G1500, and VSP F1500 storage systems in
standard and high temperature modes.
Item
Standard temperature
mode
High temperature
mode (ºF/ºC)
152
Hitachi Virtual Storage Platform G1000, G1500, and Virtual Storage Platform F1500 Hardware Guide
1
Operating
Less than 0.15 mg per cubic
meter of air
Table 37 Acoustic emission levels
Temperature (ºF / ºC)
60.8 to 77/16 to 25
77 to 89.6/25 to 32
89.6 to 104/32 to 40
Environmental specifications
Condition
2
Not operating
-
Controller chassis
Fan speed (RPM)
4200
4700
7400
3
Shipping and storage
Vertical: Rotational Edge
9
0.15m
-
Noise level (dB)
57.4
59.5
69.3