Table of Contents
Advertisement
LCD display
OVERLOAD
F70
F76
9.3. Returning to Normal Display
Press the POWER button on the unit to exit the function. The power is turned off.
9.4. Overload/Shutdown Detection intenal Condition
It detects OVERLOAD, POWER MALFUNCTION with [THRM_DET], [SHORT_DET] and [DC_DET]
input port. It detects the following condition depending on the input of the port as below table.
(H: DC ± 5V / L: DC ± 0V)
PROT
SHORT_DET THRM_DET
H
L
L
L
L
H
-
-
9.5. Overload/Thermal Detection Display
When overload is detected, automatic POWER OFF will occur. But if any key on the remote
control other than the [POWER] key is pressed before that (including the [HELP] key), the scroll
display will show [SWITCH_OFF_POWER]. Then, 1 second after display of message,
[OVERLOAD] will be shown on the scroll display.
9.6. Activating Self Diagnosis Function (Servicing Mode)
This mode can be used during servicing.
1. Plug the AC adapter to the power source. Press and hold down
the [MULTI CONTROL] button and the [SPEAKERS A] button, and
Symptom
Speaker short, amplifier failure
Humidity protection activated
Communication error between
sub micro- processor and its
peripheral LSI
When the power is turned on,
the unit power automatically
turns off; the power cannot be
turned on.
Detection of malfunction
DC_DET
H
H
Speaker Short, Malfunction of
H
Detection of THERMAL
L
Detection of POWER
Cause and Remedy
Speaker short and failure in
power amplifier, pre-amplifier
circuits. Check for faulty parts
and replace with new parts if
necessary.
Failure sub-micro processor
and its peripherals LSI. Check
for faulty parts and replace with
new parts if necessary.
Failure in the power circuit
system of the unit. This may
happen when the direct current
electricity is supplied to
speaker terminals. Check for
the above and replace with new
parts if necessary.
Normal
Amplifier
PROTECTION
MALFUNCTION
Display and operation
-----
[OVERLOAD] / POWER
[ _ _ _ F76 _ _ _ ] / POWER
OFF
Advertisement
Table of Contents
