Yamaha MT-10 2021 Owner's Manual page 27

TIP

Pushing the cruise control/YVSL
power switch " " while the cruise
control system is active and the
cruise control setting indicator light
" " is on will also switch to the
YVSL standby mode.

The cruise control system and the
YVSL control system cannot both
be active at the same time.

If the color of the speed setting in-
dicator icon has changed and
flashes, have a Yamaha dealer
check the vehicle.
12 : 00
BM 1
LIM
MPH
MPH
N
1 2
3
OFF
SCS OFF
1. Speed setting indicator icon
Adjusting the speed limit
While the YVSL is activated, push the
"RES+" side of the cruise control/YVSL
setting switch to increase the set speed
limit or the "SET–" side to decrease the
set speed limit.
TIP
Pushing the setting switch once will
change the set speed in increments of
approximately 1.0 km/h (1.0 mi/h).
Holding the setting switch will change
the set speed in increments of 5 km/h
(5 mi/h).
Deactivating the YVSL
When the YVSL is disengaged, engine
output is gradually derestricted to en-
sure a smooth transition to full rider
control of the throttle.
Perform one of the following operations
to deactivate the YVSL:
1

Turn the throttle grip past the
closed position in the deceleration
direction. The YVSL "
tor icon will go off and the system
will return to standby mode.
1. Deceleration direction

Using the resume function
Push the "RES+" side of the cruise con-
trol/YVSL setting switch to reactivate
the YVSL when in standby mode. The
speed limit will return to the previously
" indica-
set speed limit. The YVSL "
cator icon will come on.
It is dangerous to use the resume
function when the previously set
4-10
Special features
1
Push the cruise control/YVSL
power switch " " located on the
left handlebar. The YVSL display
will go off and return to the fuel me-
ter (gear display in track mode).
WARNING
1
2
3
4
5
6
7
8
9
10
11
" indi-
12
EWA21210
13