Candy CVMA60B DE Instruction On Mounting And Use Manual page 10

WARNING! Failure to install the
screws or fixing device in accordance
with these instructions may result in
electrical hazards.
• Do not use or leave the hood without
the lamp correctly mounted due to the
possible risk of electric shocks.
• Never use the hood without effectively
mounted grids.
• The hood must NEVER be used as a
support surface
indicated.
• Use only the fixing screws supplied with
the product for installation or, if not
supplied, purchase the correct screws
type.
• Use the correct length for the screws
which are identified in the Installation
Guide.
• In case of doubt, consult an authorized
service assistance center or similar
qualified person.
WARNING! Do not use with a
programmer, timer, separate remote
control system or any other device
that switches on automatically.
Electrical connection
The mains power
correspond to the rating indicated on the
plate situated inside the hood. If provided
with a plug connect the hood to a socket
in compliance with current regulations
and positioned in an accessible area,
after installation. If it not fitted with a plug
(direct mains connection) or if the plug is
not located in an accessible area, after
installation, apply a double pole switch in
accordance with
unless specifically
supply must
standards which
assures the complete disconnection of
the mains under conditions relating to
over-current category III, in accordance
with installation instructions.
WARNING! Before re-connecting the
hood circuit to the mains supply and
checking the efficient function, always
check that the mains cable is correctly
assembled.
WARNING! If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order to
avoid hazard.
Installation
• The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must not be less than
45cm from electric cookers and 65cm
from gas or mixed cookers.
• The range hood is intended to be installed over a hob
having 6 heating elements.
If the instructions for installation for the
gas hob specify a greater distance, this
must be adhered to.
As described in the installation drawings perform 6 holes (8
mm diameter, 40 mm deep), in the positions shown in the
drilling template, to fix the hood support bracket and the
exhaust flue. After installation, check that the hood and
exhaust flue are perfectly aligned.
• This appliance is marked according to the European
directive 2012/19/EC - UK SI 2013 No.3113 on Waste
Electrical and Electronic Equipment (WEEE).
• By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
• The symbol
accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it should be taken
10
on the product, or on the documents