Jeep Patriot 2014 Service Information page 49

Hide thumbs Also See for Patriot 2014:

2014 SUSPENSION Tires & Wheels - Service Information - Compass & Patriot

flange (1) and wheel stud (2).

3. Tighten the Remover, pushing the wheel mounting stud out the rear of the

hub flange. When the shoulder of the stud is past the flange, remove the

Remover from the hub.

4. Remove the stud from the hub flange.

INSTALLATION

NOTE:

Use the following procedure to install one of five studs

on one wheel hub.

Fig. 36: View Of Wheel Mounting Stud Installation

Courtesy of CHRYSLER GROUP, LLC

1. Install the NEW wheel mounting stud in the flange of the hub (2) from the

rear.

2. Install several washers (1) and a standard wheel mounting (lug) nut (3) on

the stud (4). Install the mounting nut so that the flat side of the nut is against

the washers to eliminate any binding.

3. Tighten the wheel mounting nut. This will pull the wheel mounting stud into

the hub flange. When the head of the stud is fully seated against the rear of

the hub flange, remove the wheel mounting nut and washers.

4. Install the brake rotor and all components previously removed to access it.

Refer to ROTOR, BRAKE, INSTALLATION .

Tuesday, July 19, 2016 10:01:58 AM

2014 Jeep Patriot Limited

Page 49