Jeep Patriot 2014 Service Information page 26

Hide thumbs Also See for Patriot 2014:

2014 SUSPENSION Tires & Wheels - Service Information - Compass & Patriot

when the vehicle is driven at speeds over 15 mph (24 km/h). Anytime the

vehicle speed drops below 15 mph (24 km/h), the sensor mode will still be

in Drive Mode, but will not transmit until the vehicle reaches speeds over 15

mph (24 km/h) once again. If the vehicle has been stationary for more then

20 minutes, the sensor state will transition to Park Mode.

Each sensor's (transmitter) broadcast is uniquely coded so that the wireless

control module (WCM) can monitor the state of each of the sensors on the four

rotating road wheels. The WCM can automatically learn and store the sensor's ID

while driving "within 10 minutes continuously above 15 mph (24 km/h)" after a

sensor has been replaced. The vehicle must be stationary for more then 20

minutes in order to initiate the learning sequence. The WCM can also learn the

sensor's ID using the TPM-RKE Analyzer, Special Tool 9936, with the Scan

Tool following the procedure listed in the appropriate diagnostic information.

REMOVAL

1. Raise and support vehicle.

2. Remove tire and wheel assembly.

CAUTION: The cap used on this valve stem contains an

CAUTION: The valve stem used on this vehicle is made of

Tuesday, July 19, 2016 10:01:58 AM

2014 Jeep Patriot Limited

O-ring seal to prevent contamination and

moisture from entering the valve stem. Do not

substitute a regular valve stem cap in its place.

aluminum and the core is nickel plated brass.

The original valve stem core must be

reinstalled and not substituted with a valve

stem core made of a different material. This is

required to prevent corrosion in the valve stem

caused by the different metals.

Page 26