Siemens SIMATIC NET Installation Manual page 11

Introduction
1.2 Description
1
2
3
4
5
6
7
Figure 1.1
Communication Ports
Port Status Indicator LEDs
Display Mode Indicator LEDs
Mode Button
Alarm Indicator LED
Power Module Indicator LEDs
RS-232 Console Port
2
Fiber or Copper Ethernet Ports
Port Status Indicator LEDs
Mode Button
RS-232 Serial Console Port (RJ45)
Display Mode Indicator LEDs
Alarm Indicator LED
Power Module Indicator LEDs
RUGGEDCOM M2100F
1
Ports for communicating with other devices or accessing the
RUGGEDCOM M2100F operating system are described in
"Communication Ports (Page
Port status indicator LEDs indicate the operational status of each
port, dependent on the currently selected mode.
Mode
Status Green (Solid)
Green (Blinking)
Off
Duplex Green
Orange
Off
Speed Green (Solid)
Green (Blinking)
Orange (Solid)
Off
The display mode indicator LEDs indicate the current display mode
for the port status indicator LEDs (i.e. Status, Duplex or Speed).
The Mode button sets the display mode for the port status indicator
LEDs (i.e. Status, Duplex or Speed). It can also be used to reset the
device if held for 5 seconds.
The alarm indicator LED illuminates when an alarm condition exists.
The power module indicator LEDs indicate the status of the power
modules.
• Green – The power supply is supplying power
• Red – Power supply failure
• Off – No power supply is installed
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
5
2 3 4
21)".
Color/State Description
Link detected
Link activity
No link detected
Full duplex mode
Half duplex mode
No link detected
100 Mbps
1000 Mbps
10 Mbps
No link detected
RUGGEDCOM M2100F
Installation Manual, 04/2022, C79000-G8976-1342-09
6
7