C-Data CD5204WL Quick Start Manual page 4

The back panel has the connections and button shown in the following figure. The back panel has the connections and button shown in
Ethernet Ethernet
Power Connector Power
Power Power Button
Front Panel Front Panel
The router front panel has the status LEDs shown in the following figure. The router front panel has the status LEDs
LED LED
POWER POWER
SYS SYS
LOOP LOOP
LINK LINK
LAN1-2 LAN1-2
STB1-2 STB1-2
Interface Interface Qty Qty. .
Cable Cable 1 1
TV TV 1 1
LAN LAN 2 2
STB STB 2 2
Connector 1 1
Button 1 1
Reset Reset 1 1
WLAN WLAN 1 1
Description Description
Solid Solid green. green. Power Power is is supplied
Solid green. System has started. Solid green. System has started.
Blinking green. The EOC slave is starting up. Blinking green. The EOC slave is starting up.
If If the the loop loop happened happened the
•Solid green. The CABLE port has detected a link with the EOC •Solid green. The CABLE port has detected a link with the EOC
Master by coaxial cable network. Master by coaxial cable network.
•Blinking green. Data is being transmitted or received. •Blinking green. Data is being transmitted or received.
•Off. The unit is off or there is no link established. •Off. The unit is off or there
•Solid green. The LAN port has detected an Ethernet link with a •Solid green. The LAN port has detected an Ethernet link with a
device such as a computer. device such as a computer.
•Blinking green. Data is being transmitted or received. •Blinking green. Data is being transmitted or received.
•Off. No link is detected on this port. •Off. No link is detected on this port.
•Solid green. The STB port has detected an Ethernet link with a •Solid green. The STB port has detected an Ethernet link with a
device such as a computer. device such as a computer.
•Blinking green. Data is being transmitted or received. •Blinking green. Data is being transmitted or received.
De Descrip
Connect to to uplink Connect uplink CA CATV TV network network
Connect to to STB Connect STB or or TV TV by by Cable
Ethernet LANn ports for connecting to PC Ethernet LANn ports for connecting to PC
Router Mode. WAN connection can get the IP address from Router Mode. WAN connection can get the IP address from
upper-layer device. upper-layer device.
Ethernet ports for connecting to PC, the user-side IP Ethernet ports for connecting to PC, the user-side IP
address is obtained through the upper-layer device. address is obtained through the upper-layer device.
Power Power connector connector
Power On/Off Power On/Off
Reset button Reset button
Wifi Wifi button button
shown in the following figure.
supplied to to the the EOC EOC slave. slave.
the LOOP LOOP led led will will on on
is no link established.
the following figure.
scrip tion tion
Cable
， ，
can work on can work on