Advertisement
Attaching the output stacker tray to the conveyor
Instructions for attachment of the stacker tray to the conveyor unit:
1. Place the shingling conveyor upright onto it's legs. Remove the 2 small Phillips head screws from each side of
the conveyor unit. Retain screws and backing - these will be re-inserted once the stacker tray is manoeuvred
into place.
2. Remove the backing plate from each side and slide the stacker output tray into place
3. Align the screw holes in the conveyor with the stacker output tray, re-insert the backing plate and secure with
original screws. Secure stacker tray through the top of the conveyor using the three stacker tray screws (Z)
Intec Shingling Conveyor Installation Guide
Preparing your Intec printer and aligning the conveyor
Instructions for preparing your Intec printer to receive the shingling conveyor:
1. Open the stacker face up exit tray of your Intec printer.
2. Locate the tray sensor tab to the rear of the tray, and with a knife remove the tab cleanly so there is nothing
protruding. This tab removal will allow your media to transport through the exit flap.
3. The exit flap is a closed and hinged flap which runs the width of the tray. Once located, lift the exit flap through
180 degrees and lock into position to open the exit slot. Close the stacker face up exit tray.
7
Intec Shingling Conveyor Installation Guide
8
Advertisement
