• Report any missing items or shipping damage to Intec support: support@intecprinters.com About this manual This manual is intended for use by end users and Intec trained installation engineers. It explains how to install the Intec shingling conveyor for your Intec printer. Before you start One (1) person may complete the setup of the Intec shingling conveyor.
Z - Stacker tray screw x 3 Assembling the conveyor legs Instructions for assembling the Intec conveyor legs before attaching to the Intec printer: 1. Remove the securing pin from the bottom of the front leg and remove the metal bar.
1. Open the stacker face up exit tray of your Intec printer. 1. Place the shingling conveyor upright onto it’s legs. Remove the 2 small Phillips head screws from each side of the conveyor unit. Retain screws and backing - these will be re-inserted once the stacker tray is manoeuvred into place.
Connecting power 4. Roll the shingling conveyor into position. The conveyor table will not be at the correct height. Adjust height of front legs by inserting height adjustment screw (X) into the top of front legs and turning in a clockwise rotation.