Advertisement
Preface
Every effort has been made to ensure that the information in this document is complete, accurate and up to date.
Intec assumes no responsibility for the results of errors beyond its control. Intec also cannot guarantee that changes
in software and equipment made by other manufacturers and referred to in this guide will not affect the applicability
of the information in it. Mention of software products, manufactured by other companies, does not necessarily
constitute endorsement by Intec.
While all reasonable efforts have been made to make this document as accurate and helpful as possible, we make no
warranty of any kind, expressed or implied, as to the accuracy or completeness of the information contained herein.
About this manual
This manual is intended for use by end users and Intec trained installation engineers. It explains how to install the
Intec shingling conveyor for your Intec printer.
Before you start
One (1) person may complete the setup of the Intec shingling conveyor.
Required tools
The following tools are required for installation (not supplied):
• Scissors or Utility Knife
• 5mm Allen Key
• Phillips Head Screw Driver
Installation
Installation space
In addition to the physical size of the Intec printer, additional clearance space is required for the shingling conveyor.
1300mm
Intec Shingling Conveyor Installation Guide
Unpacking the conveyor
Instructions for unpacking the shingling conveyor:
Checking contents
Ensure that you have all of the following items before beginning the installation:
A
750mm
3
• Place the box on a flat surface or on the floor
• Using the scissors, cut the box banding and remove top cover
• Carefully remove all packaging materials from around the conveyor unit
• Lift conveyor from box, remove shrink wrap and verify the contents
• Report any missing items or shipping damage to Intec support:
1
2
3
B
C
D
E
F
G
Intec Shingling Conveyor Installation Guide
support@intecprinters.com
1 - Conveyor
2 - Output stacker tray
3 - Cross bar
Boxed accessory kit
A - Black rectangular cap x 2
B - White round plastic cap x 4
C - Height adjustment screw (rear) x 2
D - Hardware Kit (detailed on page 5)
E - EU power cord
F - US power cord
G - Power supply
(UK power supplied where required)
4
Advertisement
