Advertisement
Z
X
Y
Assembling the conveyor legs
Instructions for assembling the Intec conveyor legs before attaching to the Intec printer:
1. Remove the securing pin from the bottom of the front leg and remove the metal bar.
2. Rotate the front legs upward to re-insert the metal bar and locking pin at the new location.
Intec Shingling Conveyor Installation Guide
X - Height adjustment screw and washer (front) x 2
Y - Cross bar screw and washer x 4
Z - Stacker tray screw x 3
3. Rotate the back legs upward to insert the metal cross bar. Secure each end of the cross bar by using 2 cross bar
screws (Y) with 2 washers.
4. Tighten the screws using a 5mm Allen Key (not provided).
Note: Ensure the screw is aligned with the corresponding hole on the metal securing bar.
Tip: Once the metal securing bar is rotated to the correct angle hold it in place with your forefinger and thumb
while turning the screw.
5. Insert white plastic caps (B) from the conveyor accessory kit into the holes in the frame.
5
Intec Shingling Conveyor Installation Guide
6
Advertisement
