HAYGAIN HG ONE User Manual page 25

Troubleshooting
The steam generator buzzer sounds when it contains water (PB Boilers only)
POSSIBLE CAUSE
The steam generator has
previously run out of water,
which activated the
thermal fuse.
Your hay chest is not on
level ground. This can
cause the hay chest to twist
or bend as it heats up,
which can create a gap
between the hay chest
and the lid.
Your hay chest cooled
down without the lid on,
which can cause the lid
to not fit the hay chest
properly.
While steaming, steam escapes from the safety cap on the steam generator
POSSIBLE CAUSE
The steam generator has
been overfilled.
The safety cap is not fully
closed due to hay or dirt.
The safety cap seal is
dirty, damaged or missing.
25
SOLUTION
When the forage has almost finished steaming, it is
normal for steam to be emitted from the sides or
drain hole of the hay chest.
Allow your Haygain Hay Steamer to cool down.
®
Move the hay chest to level ground.
Always keep the lid on the hay chest when it cools
down.
SOLUTION
Allow the steam generator to cool down. Pour
excess water out of the steam generator.
Allow the steam generator to cool down. Remove and
clean the safety cap.
Allow the steam generator to cool down. Remove
and clean the safety cap and the safety cap seal. If
the safety cap seal is damaged, replace it. To order
safety cap seals, contact your supplier. To replace a
safety cap seal, insert it in the base of the safety cap,
under the metal thread. Tip: To securely insert the
new safety cap seal, use a screwdriver.
© Haygain