Correcting Mistakes While Step Recording - Casio WK-3300 User Manual

NOTE
• Use the procedure under "Correcting Mistakes While
Step Recording" on this page to correct input mistakes
you make during step recording.
• You can add on to a track that already contains recorded
data by selecting that track in step 2 of the above
procedure. Doing so automatically locates the step
recording start point at the first beat immediately
following the previously recorded data.
• Whenever you are recording to Tracks 2 through 6, the
entire keyboard functions as a melody keyboard,
regardless of the current MODE button setting.
• When playing back data recorded with Advanced Tones
at the beginning of multiple tracks, the keyboard uses
the DSP type of the Advanced Tone that is recorded in
the track with the largest track number.
• When playing back a track that was recorded with an
Advanced Tone selected, they may be a slight delay
before the first note of the track sounds. If this happens,
try to insert a very short rest at the beginning of the
track.
Track Contents After Step Recording
In addition to notes and rests, the following data is also
recorded to the track during step recording. This data is
applied whenever the track is played back.
• Tone number
Level Meter Contents During Record/
Edit Standby
Channels 11 through 16 correspond to Tracks 1 through 6.
Whenever the keyboard is in record or edit (page E-62)
standby, the level meter display shows which tracks already
contain recorded data and which are still empty. Tracks with
four lit segments already contained recorded data, while
tracks with one lit segment are not yet recorded.
Recorded track
Not recorded track
Song Memory Function
Correcting Mistakes While Step
Recording
Memory data can be thought of as a musical score that
progresses from left to right, with the input point normally
at the far right of the recorded data.
The procedure described here lets you move the input point
to the left in order to make changes in data you have already
input. Note, however, that moving the input point to the left
and changing data automatically deletes all of the data
recorded to the right of the input point.
To correct mistakes while step
recording
1
Without exiting step recording, use the [ ]
CURSOR button to move the input point to the left.
• The REC indicator disappears from the display, and
the STEP indicator flashes.
N o t e C # 4
Measure 126/Beat 3/Clock 48
(Normal input point)
Data flow
• • • • • • • • • • • • • •
C 4
Press [ ] CURSOR button.
Measure 126/Beat 3/Clock 0
(Previous data)
Data flow
• • • • • • • • • • • • • •
C 4
Use [ ] and [ ] CURSOR
to move left and right.
E-61