22Cabl0037 - Extreme Networks XEM XTR Operation Manual

Extreme Engineering Operations Manual |

3.2. 22CABL0037

The XTR has to be connected to a 120V AC power supply; this will be with the 22CABL0037.
4. Connect the 3 x pin female circular connector on the 22CABL0037 with the 3 x pin male circular
120VAC connector on the XTR. The cable has slots that have to be aligned to corresponding
grooves on the connector. Once aligned the cable is placed on the connector and turned
clockwise to secure the connection. The cable end has a small hole, and the connector has a
corresponding pin; the cable is twisted until these are aligned.
The other end has standard 120V AC power socket and can be connected to the power supply. If
the Rig power supply is unstable or has noise, the XTR can be connected to the power supply
through the Isolation Transformer 02X-EM0006.
Private. Copyright © Extreme Engineering 2012. Unpublished Work. All rights reserved.
Figure 15 22CABL0035 connected to 120V AC on the XTR
Surface Equipment Page | 14