Schumacher Electric SE-4022 Owner's Manual page 20

Manual battery charger
Hide thumbs Also See for SE-4022:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
Ammeter reads less than
selected charge rate when
charging a discharged
battery
The charger is making an
audible clicking sound.
Charger makes a loud
buzz or hum.
POSSIBLE CAUSE
Extension cord is too long
or wire gauge is too small.
Weak cell or sulfated plate
in battery.
Battery is only partially
discharged.
Circuit breaker is cycling.
Battery is defective.
Shorted battery cables or
clips.
Severely discharged
battery, but otherwise it is a
good battery.
Reverse connections at
battery.
Transformer laminations
vibrate (buzz).
Shorted Diode Assembly or
Output Rectifier Assembly
(hum).
16
REASON/SOLUTION
Use a shorter or heavier
gauge extension cord.
A sulfated battery will
eventually take a normal
charge if left connected. If
the battery will not take a
charge, have it checked.
Continue to charge the
battery.
The settings may be wrong.
Check the charger settings.
Have the battery checked.
Circuit breaker cycles when
current draw is too high.
Check for shorted cables
or clips and replace if
necessary.
The battery may not want
to accept a charge due to
a run-down state. Allow
charging to continue until
battery has a chance to
recover sufficiently to take
a charge. If more than 20
minutes, stop charging and
have the battery checked.
Shut the charger off
and correct the lead
connections.
No problem, this is a normal
condition.
Have charger checked by a
qualified technician.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Se-5025Se-2254Se-3000Se-4020Se-6030Se-8050 ... Show all

Table of Contents