Installation - Samsung SID-70 Series User Manual

Installation

1) Separate the dome cover by turning anti-clockwise.
2) Separate the shield case by pulling from the camera body.
Latch
Locking direction
[Figure1]
Unlocking direction
(Anti-clockwise)
Notes
• T he installation should be done by qualified
service personnel or system installers.
• I f the ceiling material is not strong enough to
hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
• T o change the position of the cable, take
away the Hole Cover and pass the cable
through.
COLOR DOME CAMERA
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Main Body
(Camera)
Shield Case
Locking direction
(Clockwise)
Dome cover
Original position of
the cable
Hole Cover
10
User Guide
When using the Ceiling bracket
1) Hold the ceiling bracket (located where the arrow
Ceiling bracket
An arrow for installing
directions
2) Place the separated ceiling bracket so that the
3) To combine the main body with the ceiling bracket,
M4 tapping
screw (provided)
4) Adjust the camera lens to face the area to be
CAMERA
Locking
direction
Unlocking
direction
Dome cover
Notes
• I f you want to install the camera with the ceiling bracket combined, fix it using two M4 tapping
screws at the side of the main body (refer to the [Figure-2] on page 11).
COLOR DOME CAMERA
Installation
points to) and separate it from the main body of
the camera by rotating it anti-clockwise.
(refer to the picture in 'Notes' on page 10)
"Front" side faces the area to be monitored and
install it with the M4 tapping screws.
make sure that the pan base fixation screw face the
opposite side of the "Front" side of the ceiling
bracket and rotate it clockwise.
monitored and fix the main body and the dome
cover by aligning the grooves and rotating the
body clockwise.
Pan Base
fixation
screw
M4 tapping
screw
[Figure-2]
11
User Guide