Table of Contents
Advertisement
Remote control
This projector has eight different remote control codes; the factory-
set normal code (Code 1) and the other seven codes (Code 2 to
Code 8). This switching function prevents remote control operation
mixture (jam) when operating several projectors or video equipment
together.
For example operating projector in "Code 7," both projector and
Remote Control Unit must be switched to "Code 7."
To change the code of Projector;
To change the Remote control code of the projector used in ON-
SCREEN MENU is selectable from Code 1 to Code 8.
To change the code of the Remote Control Unit;
To change the remote control code of the Remote Control Unit, set
the DIP switches 1-3 inside the battery compartment box of the
Remote Control Unit. (Refer to P17.)
USB
This Projector is equipped with USB port for interactive operation
between a projector and computer. Set mode following steps below.
Wireless Mouse mode
Select "
" when controlling a computer with Remote Control of
this projector.
Projector mode
Select "
" when controlling a projector with computer.
NOTE: This is provided not for basic operation but for future use.
Key lock
This function locks the operation of the projector's control panel and
the remote control.
This cancels the Key lock function.
This locks operation of the projector's control panel.
This locks operation of the remote control.
If the projector's control panel accidentally becomes locked and you
do not have the remote control nearby, disconnect the AC cord to
turn off the power, and then while pressing a SELECT button,
reinsert the AC cord, This will cancel the projector's control panel
lock.
Remote control
When pressing SELECT button
at Remote control, Remote con-
trol code Menu appears.
USB
Move a pointer to item and then
press POINT LEFT/RIGHT
button(s).
Key lock
SETTING
41
Advertisement
Table of Contents
