Using Tone Effects; Layering Two Tones - Casio Privia PX-400R User Manual

Using Tone Effects

Reverb: Makes your notes resonate
Chorus: Adds more breadth to your notes
Press the REVERB CHORUS button to cycle through
1
the effect settings as shown below.
• You can find out the current effect setting by looking at
the REVERB and CHORUS indicator lamps.
After turning on the effect you want, use the dial to
2
select the effect type you want.
• Note that you need to select an effect type with the dial
within a few seconds after turning on an effect. If you don't,
the display will exit the setting screen.
Effect List
R e v e r b T
[ R o o m 0 1
C h o r u s T
[ C h o r u s 0
419A-E-009B
PX400R_e_01-16.p65
On
Both on
Off
Both off
On
Reverb on
On
Chorus on
Reverb Room 1
Room 2
Hall 1
Hall 2
Chorus Chorus 1
Chorus 2
Chorus 3
Chorus 4
e :
y p
] 0 0 0 0 0 0 0 0 0 0 0 0 0 0
e :
y p
1 ] 0 0 0 0 0 0 0 0 0 0 0 0
7
Selecting and Using Built-in Tones

Layering Two Tones

Use the following procedure to layer two tones, so they sound at
the same time.
Use the procedure under "Selecting a Tone" on page
1
E-6 to select the main tone.
Example: To select Grand Piano, press the PIANO button,
and then rotate the dial until "Grand Piano" is
displayed as the tone name.
Press the LAYER button.
2
• This causes the LAYER indicator lamp to light.
Select the layered tone.
3
Example: To select Strings
[ 0 0 0 : 0 S t r i n
g
0 P o s 0 1
p
• This will cause the indicator lamp of the layered tone (the
second one you selected) to light.
• Now you can play using your layered tones.
Grand Piano
Strings
After you are finished using the layered tones, press the
4
LAYER button again to unlayer them.
Adjusting the Volume of the Layered Tone
You can independently adjust the volume of the layered tone (the
second one you select). See page E-26 for more information.
04.8.24, 4:34 PM
s ]
E-7