WABCO OMEGA 183 210 080 2 Installation Instruction page 2

INSTALLATION INSTRUCTION
DOOR LOCK OMEGA 183 210 080 2
Scope of supply
Installation
WARNING
Danger of accidents
During assembly there is a risk of accidents due to moving vehicles and vehicle parts.
– Secure the vehicle with chocks and fasten moving vehicle parts.
CAUTION
Risk of crushing fingers/hands
During assembly there is a risk of crushing fingers/hands.
– Make sure that your fingers are not crushed.
CAUTION
Risk of injury for feet
A lock that falls from height can cause injuries due to its weight.
– Wear safety shoes during assembly.
1.
2.
3.
4.
Maintenance and care
NOTE
Damage of locking mechanism
Teflon clogs the locking mechanism.
– Never use Teflon.
Door lock Omega for door rod distances of 225 mm to 435 mm.
– Place the latch around the fastening (clamps) of the door rods with the forking
pointing towards the rear.
– Place the right lock part around the door rod on the right with the forking pointing
to the rear.
– Place the rod of the left locking piece through the right locking piece.
– Push to parts together as far as possible until they make direct contact with the
door rods.
– You may need to cut the rubber door seals for the parts to be pushed together far
enough.
Ö The parts are sufficiently close to one another if you can insert a padlock into
the provided holes.
– Insert the pad of the padlock through the lock from the top and lock it with the
padlock's locking piece.
For locking, use an Mul-T-Lock Padlock C13 13 mm (183 100 001 4).
The VdS certificate is only valid if the Mul-T-Lock Padlock is used and becomes
invalid when the door lock Omega is fitted inappropriately.
Ö The forking must embrace the door rods so that the doors can no longer be
opened.
Mechanical parts: no maintenance or care required. Damage
to the paintwork must be repaired as quickly as possible.
Cleaning and care of the cylinder: Use brake cleaner for
cleaning. Then drip a little light oil into the keyhole and rotate
back and forth a few times with the key.
Suitable oil types: Sewing machine oil, gun oil, low-viscosity
synthetic engine oil.
400 608 150 0 400 608 151 0
400 608 153 0 400 608 154 0