Ping-Pong Test Procedure - Semtech SX1211SK User Manual

3.6

PING-PONG TEST PROCEDURE

The Ping Pong Settings flowchart is shown Figure 3.3. At the end of this process the Ping Pong test
will start automatically.
Ping Pong Test
Settings
Modulation and
Frequency band
Selection
Reset Master board
and Slave board
Power On the
boards
Select the
modulation type
Select a Master and
a Slave
Ping Pong Test
End Settings
Auto jump mode
Rev1.1
SX1211SK868/915 User Guide
Figure 3.3: Ping-Pong Settings flowchart
10 of 30
Refer to paragraph 3.6.1
Refer to paragraph 3.6.2
Refer to paragraph 3.6.3
Refer to paragraph 3.6.4
Refer to paragraph 3.6.5 and 3.6.5
TX LED is blinking
RX LED in On
Refer to paragraph 3.6.7
www.semtech.com