Sanyo PLC-UF15 Owner's Manual page 42

SETTING
USB
This Projector is equipped with USB port for interactive operation
between a projector and computer. Set mode following steps below.
Wireless Mouse mode
Select " " when controlling a computer with Remote Control of
this projector.
Projector mode
Select " " when controlling a projector with computer.
NOTE: Before you control a projector by computer, install USB driver
(optionally sold parts) and set up computer following instruc-
tion in USB driver package. Contact your authorized dealer.
Lamp counter reset
Be sure to reset Lamp Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP
REPLACE indicator stops lighting.
Turn projector on, press MENU button and ON-SCREEN
1
MENU will appear. Press POINT LEFT/RIGHT button(s) to
move a red frame pointer to SETTING Menu icon.
Press POINT DOWN button to move a red frame pointer to
2
"Lamp counter reset" and then press SELECT button.
Move arrow to replaced lamp number (Lamp 1, Lamp 2, Lamp 3
3
or Lamp 4) and then press SELECT button. Message "Lamp
replace counter Reset?" is displayed. Move pointer to [Yes] and
then press SELECT button.
NOTE: Be sure to reset correct lamp number otherwise LAMP
REPLACE indicator continues lighting.
4 Another confirmation dialog box appears and select [Yes] to
reset Lamp Replace Counter.
Do not reset Lamp Replace Counter except after Projection lamp is
replaced.
Quit
Closes SETTING MENU.
42
USB
Press SELECT button at this icon to
display previous items.
Move a pointer to item and then
press POINT LEFT/RIGHT
button(s).
Move pointer to Lamp counter reset and then
1 3
press SELECT button.
2 4
replaced lamp number (Lamp 1, Lamp
2, Lamp 3 or Lamp 4) and then press
SELECT button.
Message "Lamp replace counter Reset?" is
displayed. Move pointer to [Yes] and then
press SELECT button.
Move arrow to