Listening To The Demo Songs - Korg KRONOS2-61 Quick Start Manual

Samples Not Loaded message
If a Program, Combination, or Song needs samples which
are not currently loaded, the Samples Not Loaded message
appears at the top of the display. You can use the Load
required samples menu command to resolve this in a single
step.
To load the sample data:
1. Go to the P0:Play page of the current mode.
2. Select the "Load required samples" menu command.
A dialog box will appear with a list of all of the un-loaded
Multisamples, Samples, and/or Drum Samples.

Listening to the demo songs

Loading the demo songs
1. Press the DISK button (the LED will light) to enter
Disk mode.
2. If you've edited or created any new sounds or songs,
save them before proceeding!
Loading the demo songs will replace the contents of the
internal memory, including Programs, Combinations,
Songs, sample data, and so on. If you've made any edits,
save them to the internal disk or a USB drive before you
proceed.
3. Press the File tab and then the Load tab, to go to the
Load page.
4. Make sure that "Drive Select" is set to
HDD:INTERNAL HD.
The contents of the hard disk will appear.
5. Touch the FACTORY directory to select it.
6. Press the Open button to enter the directory.
7. Touch the PRELOAD.SNG file to select it.
This file contains the demo song, along with all of the
sounds that it needs.
File tab Drive Select PRELOAD.SNG
Load tab
8. Press the Load button to open the dialog box.
9. Select the "Load PRELOAD.PCG too" check box.
With this option checked, the matching .PCG file will be
loaded along with the .SNG file.
3. Select the "Load only required samples" radio button
to load the listed data.
or:
Select the Load complete banks radio button to load
the entire bank(s) containing the listed data.
4. Press Load to load the data, or Cancel to exit without
loading.
If you switch between the radio buttons, the Memory
Required and (Memory) Available displays will update as
necessary. If there isn't enough room, the Load button will
be disabled.
10.Select the "Load PRELOAD.KSC too" check box.
With this option checked, the matching .KSC file will be
loaded as well.
11.Set .SNG Allocation to Clear.
12.Set .KSC Allocation to Clear All.
13.Press the OK button to load the data.
Playing the demo songs
1. Press the SEQ button (the LED will light) to enter
Sequencer mode.
If you haven't done anything with Sequencer mode since
turning on the power, the P0: Play/REC– MIDI Track Prog
Select/Mixer page will appear.
If this page is not displayed, press the EXIT switch several
times. Although the exact number will depend on the page
you're in, pressing the EXIT switch no more than three times
will always bring you back to this page.
Let's start by listening to song S000.
2. Verify that song S000 is selected.
If another song is selected, touch the song name to highlight
it. Then press the numeric key 0, and then the ENTER
switch.
Load tab
3. Press the SEQUENCER START/STOP switch.
The LED will blink, and the song will begin playing back.
4. If you want to stop playback mid-way through the
song, press the START/STOP switch once again.
Let's listen to the next song.
Saving and loading data
En-
27