Rear Fan - Lenovo ThinkStation P360 Tower Hardware Maintenance Manual

Note: Align the new rubber mounts of the new front fan with the corresponding holes in the chassis. Push
the rubber mounts through the holes. Pull the tips of the rubber mounts until the front fan is secured in place.

Rear fan

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the "Computer cover" on page 53.
2. Disconnect the rear fan cable from the rear fan connector on the system board.
Replacement procedure
Note: The rear fan is attached to the chassis by four rubber mounts. Break or cut the rubber mounts and
gently pull the rear fan out of the chassis.
.
Chapter 7 Hardware removal and installation
83