Sanyo NV-E7000 Service Manual page 15

ADJUSTMENT PROCEDURES
SIGNAL
3. FLICKER Adjustment
< Adjustment conditions >
Adjustment shall be done with the combination of a paired LCD module.
Adjustment in TEST MODE.
Display map in NAVI MODE.
Adjust each video signal value by default value.
(BLACK : CENTER. DIMMER : MAX .)
1) FLICKER adjustment
Give a shock to the set, and adjust the [FLICKER] to make the FLICKER
visually optimal.
4. DISPLAY POSITION ADJUSTMENT
< Adjustment conditions >
Display the following screen in NAVI MODE, and adjust the VOLUME on the
reverse side of the LCD module to make the both ends of right and left of the
screen equalize.
SAME STEPS
V BLACK-WHITE VOLTAGE
B W
V BLACK-BLACK VOLTAGE
B B
Figure1
Check disc.
_
14
BLACK LEVEL
WHITE LEVEL
Right and left of the both ends of
the white line shall be equalized.
_
V
B B
V
B W