Table of Contents
Advertisement
4. Adjust the camera angle so that the extreme rear
end of the vehicle (bumper, rear window, and
liftgate.) is displayed at the bottom of the monitor.
•
After adjusting the angle, tighten the screws
with them seated at the lower end of the
oblong holes in the bracket on each side.
CAUTION
•
Verify the tightness of the screws and tighten them more if necessary.
CAUTION
•
After installing the camera, the screen displays
an approximate 135-degree view between the
left and right, and an approximate 105-degree
view between up and down. The rear view back
up camera system is a device designed only to
assist the driver. The driver must take full
precautions to confirm the safety and conditions
around the vehicle.
5. Locate a position to install the ECU box where all
the cables are within connection reach.
CAUTION
•
Avoid installing near the ventilators for the
heater.
6. Peel off the paper backing from the Hook-and-loop
fastener (1 set.), adhere each piece to the bottom of
the ECU box, and install the ECU box in the
position determined in Step 5.
Note
• There are separate surfaces for each piece
of Hook-and-loop fastener. Attach the rough
surface to the bottom of the ECU box, and
the soft surface to the location where the
ECU box is to be installed.
•
If the rough surface of the Hook-and-loop fastener
attached to the bottom of the ECU box adheres to
floor without need for the mating piece, attach the
ECU box directly to the vehicle floor without using
the mating piece.
Need help? Call
1-800-421-5013
Loosen
Approx. 135°
Hook-and-loop
(Rough side)
−13−
Extreme rear end of vehicle
(bumper etc.)
Tighten
ECU box
ECU box
Hook-and-loop
fastener (Soft side)
Floor
fastener
Approx.
105°
Advertisement
Table of Contents
