Factory Reset - Sangean DDR-31+ User Manual

Factory reset

If your clock radio fails to operate correctly or some digits on the
display are missing or incomplete, carry out the following procedures.
1. Press and release the On / StandBy button to switch on your
clock radio.
2. Press and release the Advanced button. When the DDR-31 Plus is
tuned to a DAB radio station, the display will show "Manual tune."
Note:
Press and release the Advanced button. When the DDR-31 Plus is tuned
to an FM station, the display will show "FM scan zone".
3. Press the Tuning Up or Down buttons until the display shows
"System".
4. Press and release the Select button to enter the adjustment mode.
5. Press the Tuning Up or Down buttons until the display shows
"Factory reset".
6. Press and release the Select button to enter the Factory reset menu.
7. Press the Tuning Up or Down buttons to switch the <No> or <Yes>.
8. Press the Tuning Up or Down buttons to select YES, then press and
release the Select button to start the Reset, the display will appear
"Restarting...".
9. A full reset will be performed, the station list and presets will
be erased. The display will show "Welcome to Digital Radio" for a few
seconds and then the flash clock digits and the display will show
"Time is not set". When the factory reset is complete, you can set
new settings. In case of malfunction due to electrostatic discharge,
reset the product (reconnection of power source may be required) to
resume normal operation.
31