Table of Contents
Advertisement
Oven Light
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
WARNING
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
CAUTION
bare hands or a damp cloth can cause burns.
Oven Light Replacement (on some models)
To remove:
1. Turn the glass cover counterclockwise 1/4 turn until the tabs
of the glass cover clear the grooves of the socket. Wearing
latex gloves may offer a better grip.
2. Using gloves or a dry cloth, remove the bulb by pulling it
straight out.
To replace:
1. Use a new 120/130-volt halogen bulb, not to exceed 50
watts. Replace the bulb with the same type of bulb that was
removed. Be sure the replacement bulb is rated 120 volts or
130 volts (NOT 12 volts).
2. Using gloves or a dry cloth, remove the bulb from its
packaging. Do not touch the bulb with bare fingers. Oil from
skin will damage the bulb and shorten its life.
3. Push the bulb straight into the receptacle all the way.
4. Place the tabs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise 1/4 turn.
For improved lighting inside the oven, clean the glass cover
frequently using a wet cloth. This should be done when the
Oven Light Replacement (on some models)
To remove:
1. Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass
cover clear the grooves of the socket.
Wearing latex gloves may offer a better
grip.
2. Remove the bulb by turning it counter-
clockwise.
Oven Light Replacement (on some models)
The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped wire. Remove
the oven door, if desired, to reach the cover easily. See the Lift-Off Oven Door section for detailed oven door
removal instructions.
Replacing the Light Bulb:
1. Disconnect electrical power to the range.
2. Hold the glass cover stable, so it doesn't fall when
released.
3. Slide near the indent of the cover holder until the
cover is released. Do not remove any screws to
release the glass cover.
4. Replace bulb with a 40-watt household appliance
bulb. Do not touch hot bulb with hand or wet
cloth. Only remove bulb when it is cool.
5. Hold glass cover stable over new bulb.
49-2001056 Rev. 0
oven is completely cool.
5. Reconnect electrical power to the oven.
Socket
Receptacle
G9 Bulb
Tab
Glass cover
To replace:
1. Replace bulb with a new 40-watt appliance bulb. Insert the
bulb and turn it clockwise until it is tight.
2. Place the tabs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise 1/4 turn.
For improved lighting inside the oven, clean the glass cover
frequently using a wet cloth. This should be done when the
oven is completely cool.
3. Reconnect electrical power to the oven.
6. Pull the wire cover holder near the indent until the
indent in the
Glass cover
wire cover
(on self clean
holder is located
model only)
in the indent of
the glass cover.
7. Connect
electrical power
to range.
Receptacle
Use gloves
or cloth
Indent
Wire cover holder
25
Advertisement
Table of Contents
