Page 1
USER MANUAL Thermostatic Shower Set Large Ceiling Rainfall Shower System Thank you for shopping with Hernest, please read this user manual thoroughly for your full under- standing, installing, and application of the product. Please have this user manual well-reserved for future reference.
Page 2
Shower Set Installation Guide 16.9"(430mm) 27.6"(700mm) 1.9"(49mm) ④ ④ 0.7"(17mm) 21.4"(543mm) 2.4”(62mm) ① ② ③ Cold Unit: Inch(mm) ① ② ③ ④ Hot Water Cold Water Mixed Water Mixed Water...
Size Reference Please proceed your installation base your actual size measurement, this image is for reference only. 21.3"(543mm) Temperature Mixer water outlets control handle Inlets:3/4"NPT Outlets:1/2"NPT Installation Steps 21.3"(530mm) Outlet 1 Outlet 2 Outlet 3 Outlet 4 Outlet 5 Turn off the water supply, confirm the Drill 4 Positioning holes for the valve length and depth for the pipes.
Page 4
Insert the 4 expansion screws into the Fix the valve main body with 4 screws. holes with a hammer. Waterfall Bubbles Rainfall Leak Block Body jets Hand shower Tighten the screws with a copper sleeve Connect the hot/cold inlets and outlets wrench.
Page 5
Installation Steps Of Hand Shower Wrap the the thread of connector with Install the shower holder on the water sealing tape. inlet and tighten it clockwise. Hand shower Sealing Rubber Ring Shower Hose Connect the shower head, the shower fixture, and the shower hose, then place the shower on the shower fixture.
Page 6
Installing The Touch Switch Use a tool’s flat and thin part (like a slotted screwdriver) to insert and crack the top groove Touch panel Transmission 3.4"(86mm) belt Electrical bottom box (not provided) Prepare the groove and install the Use a tool(not included) to crack the electrical bottom box on the wall, size groove on the top to open the front reference: 3.4(86mm) side length.
Page 7
Cover the front panel of the touch switch Connect the power cord and power and its main body. plug. Installing The Touch Switch Item ① ① Expansion screws ② Frame ③ Connect hose 1 ② ④ 1/2 thick weaving hose ⑤...
Page 8
Installing The Touch Switch Hexagon wrench Loosen the 4 screws by unscrewing Separate the shower parts and main them with the hexagon wrench counter- body. clockwise. 19.8"(503mm) 13.1"(333mm) 22.2"(565mm) Chisel the groove on the ceiling based Drill 8 holes with φ 12mm in the groove on the actual size of the product.
Page 9
Protruding part of the expansion screws Frame Gasket Protruding part of the expansion screws Spring washer Wrench Frame Install the frame, make the protruding put the gasket and spring washer back parts of the 8 screw align and through on the screw, and tighten the nuts on the corresponding holes.
If you have any issues with the product, please feel free to contact us online or by phone for customer service. Phone Number: (909) 430-1666 Service E-mail: service@hernest.com For more detail information, please check out www.hernest.com It will be our pleasure to have your visit. www.hernest.com...
Need help?
Do you have a question about the H200228 and is the answer not in the manual?
Questions and answers