Advertisement
INSTALLATION INSTRUCTIONS
_______________________________________________________________
Thank you for choosing STAINLESS STEEL BRAKES CORPORATION for your braking
needs. Pleases take the time to read and carefully follow these instructions to insure the ease of
your installation as well as the proper performance of the complete system.
Before beginning your installation, please verify you have received all the parts indicated on
the packing slip. If you believe anything to be missing or incorrect, please call our Customer Service
Department at 716-759-8666.
To assure your installation will go safely and smoothly, have the following items on hand to
assist you:
Revision 2 3/5/12
Stainless Steel Brakes Corporation • 11470 Main Road • Clarence, NY 14031
FRONT BIG BRAKE CONVERSION KIT A112-5
1987-93 FORD MUSTANG
JACK & JACK STANDS
LUG WRENCH
TORQUE WRENCH
SOCKET SET
BRAKE CLEANER
Phone: (800) 448-7722 • (716) 759-8666 • Fax: (716) 759-8688
www.ssbrakes.com • info@ssbrakes.com
WRENCH SET
TUBE WRENCH
MALLET
WHEEL BEARING GREASE
BRAKE FLUID
This kit uses the following pads:
SSBC#:
FMSI#:
1061-1
D-199
Advertisement
Table of Contents
Related Manuals for SSBC A112-5
Summary of Contents for SSBC A112-5
- Page 1 INSTALLATION INSTRUCTIONS FRONT BIG BRAKE CONVERSION KIT A112-5 1987-93 FORD MUSTANG _______________________________________________________________ Thank you for choosing STAINLESS STEEL BRAKES CORPORATION for your braking needs. Pleases take the time to read and carefully follow these instructions to insure the ease of your installation as well as the proper performance of the complete system.
- Page 2 AND THOROUGHLY READ THROUGH THIS INSTRUCTION MANUAL TO ENSURE THAT YOU HAVE ALL OF THE PARTS NEEDED TO COMPLETE THE INSTALL! IF YOU FIND YOU ARE MISSING ITEMS, PLEASE CONTACT SSBC IMMEDIATELY, REGARDLESS OF WHAT DEALER YOU PURCHASED THIS KIT FROM.
- Page 3 Connect the adapter TEE (3 port) to the “third” brake tube. This is the tube that was originally connected to the bottom of the master cylinder. Leave the fittings finger tight at this point. Install the new master cylinder onto the booster and secure with the original lock nuts. A112-5 Revision 2...
- Page 4 FINAL INSPECTION Once a hard pedal is achieved, all fittings and connections must be inspected to make sure there are no leaks. Also check the level in both reservoirs of the master cylinder and top off if needed. A112-5 Revision 2...
- Page 5 BRAKING TESTS SHOULD ALWAYS BE DONE IN A SAFE OPEN AREA! NOTE: For frequently asked questions and technical reference information please visit the tech section of our website at www.ssbrakes.com. TECH LINE -- If technical help is required, please call 716-759-8666. NOW ENJOY TRUE PERFORMANCE BRAKING!! A112-5 Revision 2...
- Page 6 Photo #1 Illustration #1 - Combination Valve A112-5 Revision 2...
- Page 7 This can easily be done by bench bleeding the master cylinder prior to installation. Using the SSBC master cylinder bleeder kit (#0460): 1) Place your master cylinder in a vise by the ears (not body).
Need help?
Do you have a question about the A112-5 and is the answer not in the manual?
Questions and answers