Troubleshooting - Samsung FE-N500 Series User Manual

troubleshooting

TrouBleShooTinG
Samsung works hard to ensure that you don't have problems with your new electric range. If you run into
unexpected trouble, look first for a solution in the table below. If, after trying the suggested solution, you're
still having trouble, call Samsung at 1-800-SAMSUNG (1-800-726-7864).
PROBLEM
The range is not
level.
The appliance
must be accessed
for servicing and
cannot be moved
easily.
The oven control
beeps and displays
an F error code.
66_ Troubleshooting
POSSIBLE CAUSE
The appliance has been installed
improperly.
The floor is sagging or sloping.
The kitchen cabinets are not
properly aligned and make the
range appear to be not level.
The kitchen cabinets are not
square and are too tight around
the appliance.
The carpet is interfering with
movement of the range.
You have a function error code.
CODE CAUSE
-SE- Shorted key
E-27 Oven sensor opened
E-28 Oven sensor shorted
E-08 Oven heating error
E-0A Oven heating over
E-0E Door locking error
E-54 Communication error
(Oven main - HYB30M)
E-55 Communication error
(Oven main - Touch PCB)
E-56 Communication error
(Cooktop error)
SOLUTION
• Place the oven rack in the center of the
oven. Place a level on the oven rack.
Adjust the leveling legs at the base of the
range until the oven rack is level.
• Insure the floor is level and strong and
stable enough to adequately support the
range.
• Contact a carpenter to correct the
situation.
• Insure the cabinets are square and provide
sufficient room for installation.
• Contact a builder or installer to make the
appliance accessible.
• Provide sufficient space so the range can
be lifted over the carpet.
• Press the CLEAR/OFF pad and restart
the oven. If the problem persists,
disconnect all power to the range for at
least 30 seconds and then reconnect the
power. If this does not solve the problem,
call for service.