Table of Contents
Advertisement
• The new software will be downloaded from the Internet. The RA-6000
will power cycle when the software update is complete.
NOTE: Do NOT power off the RA‑6000 during the software update
process.
NOTE: It is recommended to Reset Factory Defaults after the software
update is complete.
• FACTORY DEFAULT: This sets the unit back to the original state as when
it left the factory. Press the + button on the front panel or RIGHT arrow
button on the remote control to select <YES> then press the "ENTER"
button on the front panel or on the remote control.
NOTE: All previously configured options will be erased and reset to
the factory default settings.
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the fault
and make the necessary changes. If you are unable to get sound from the
RA-6000, refer to the suggestions for the following conditions:
Power Indicator Is Not Illuminated
The Power Indicator ring around the power button and the basic items in the
Display window should be illuminated whenever the RA-6000 is plugged
into the wall power outlet and the POWER switch is pushed in. If it does not
light, test the power outlet with another electrical device, such as a lamp.
Be sure the power outlet being used is not controlled by a switch that has
been turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet, but
the Power Indicator still will not illuminated when the RA-6000 is plugged
into the wall outlet, it indicates that the internal power fuse may have blown.
If you believe this has happened, contact your authorized Rotel dealer to
get the fuse replaced.
No Sound
Check the signal source to see if it is functioning properly. Make sure the
cables from the signal source to the RA-6000 inputs are connected properly.
Check the wiring between the RA-6000 and the speakers.
Cannot Connect via Bluetooth
If you cannot pair your Bluetooth enabled device to the RA-6000, delete the
memory of the previous connection on your device. On your device this is
often listed as "Forget this Device". Then try to make the connection again.
Playable Audio Formats
USB Apple (iPhone, iPod, iPad)
Format
Any supported file loaded to Apple device. Phone may
Any supported file
resample depending on stored format. May exclude
loaded to Apple
Apps designed to play formats not originally supported
device.
by the sending device.
aptX™
HD
and AAC Bluetooth
Format
Any format supported
May exclude Apps designed to play formats not originally
by the sending device.
supported by the sending device.
PC-USB
Format
Any supported format by the PC software
Format determined
PCM Audio:
by the Media Player/
44.1k, 48k, 88.2k, 96k, 176.4k,
Server software that
384k (16 bit, 24 bit and 32 bit)
you use.
MQA, MQA Studio (24 bits/384kHz)
Roon Tested
Coax/Optical
Format
44.1k, 48k, 88.2k, 96k, 176.4k, 192k
SPDIF LPCM
16 bit, 24 bit
17
Notes
Notes
Notes
192k, 352.8k
Notes
Advertisement
Table of Contents
