Related Manuals for MTH PUMPS T31 Series
Summary of Contents for MTH PUMPS T31 Series
- Page 1 Section T31 Dated February 2011 Part No. 64-3520-01-588 T31 SERIES Repair Instructions PUMP ENDS...
- Page 2 Section T31 Dated February 2011 Part No. 64-3520-01-588 T31 SERIES Repair Instructions 5B Disassembly PUMP ENDS The following tools and equipment A. Preliminary are needed for disassembly of T31 B. Disassembly Series Pumps. C. Inspection of Components D. Reassembly 1. Soft plastic or wooden mallet.
- Page 3 Section T31 Dated February 2011 Part No. 64-3520-01-588 during reassembly. 4. Remove the impeller. This is easily done by setting the motor 5C Inspection of Components on end. The impeller is a slip fit and under normal conditions, can be removed by hand or by Thoroughly clean all parts.
- Page 4 Section T31 Dated February 2011 Part No. 64-3520-01-588 If seal components must be reused, a. Place the motor bracket face carefully inspect for microscopic up on a flat surface. cracks and nicks. Scratches that might be ignored elsewhere can b. Apply a coating of compat- produce leakage if they are on seal ible lubricant to the elastomer carbons and seat wearing surfaces.
- Page 5 Section T31 Dated February 2011 Part No. 64-3520-01-588 T31 SERIES Repair Instructions Figure 5-2 T31 CLOSE COUPLED PUMP NAME/DESCRIPTION PART NO. QTY. Motor Bracket Cover "O" Ring/Casing "O" Ring/Tru Bolt Snap Ring Impeller Seal Rotating Element Seal Stationary Seat Thru Bolt...
- Page 6 Section T31 Dated February 2011 Part No. 64-3520-01-588 5. Install the impeller key (#23) into 3. Make sure all valves are opened, the shaft keyway. and fluid will flow through the sys- tem. 6. The impeller is a slip fit and should slide on firmly but easily 4.
- Page 7 Section T31 Dated February 2011 Part No. 64-3520-01-588 Installation Notes Serial #: Install Date: Distributor Name: Maintenance & Service Record Procedure Date New pump installation into system...
- Page 8 Section T31 Dated February 2011 Part No. 64-3520-01-588...
Need help?
Do you have a question about the T31 Series and is the answer not in the manual?
Questions and answers