Table of Contents
Advertisement
2. In normal operation mode, press the Up button (
DHW temperature (
) is highlighted on the screen.
3. Press the OK button (
) to select the DHW temperature
temperature (
). The highlighted section will flash.
4. Press the Up button (
) or the Down button (
desired temperature appears on the display. You can adjust
the temperature while the display is flashing. Once the
display stops flashing, the temperature setting is stored.
Take note of the original water temperature in case
Note
●
you want to restore it to the default.
The default DHW temperature range is 30°C to
●
65°C.
The boiler will retain your settings during a power
●
outage.
The DHW temperature cannot be adjusted, when
●
the Heat Demand function is set to OpenTherm.
3.3 Viewing Basic Information
) The
To view information about the boiler, press the Menu button
(
), and then select "2. Status Information".
Press the Up button (
between the information items. Press the OK button (
select an item and view the information.
Press the Back button (
1. Operation State
2. Heat Capacity
3. CH Set Temp
4. DHW Set Temp
) until the
5. Supply Temp
6. Return Temp
7. Outdoor Temp
8. Inlet Temp
9. DHW Temp
10. Water Flow
11. Water Press
12. Flame Value
13. Fan Target RPM
) or the Down button (
) to exit information view mode.
Item
Description
Current Operation State
Heat capacity (%)
Central heating set temperature
(°C)
DHW set temperature (°C)
Heating supply temperature
(°C)
Boiler return temperature (°C)
Outdoor temperature (°C)
Inlet temperature (°C)
DHW temperature (°C)
Water flow rate (LPM)
If the rate is 0, "Calculation" will
be displayed.
Water pressure (bar)
Flame detector AD value
Flame On: 8bit AD values
●
equal to or lower than 70
Flame Off: 8bit AD values
●
equal to or higher than 175
Fan target speed (RPM)
) to switch
) to
Operating the Boiler
11
Advertisement
Table of Contents
