Programming; Setting Current Time And Date - DIG RBC 8000 Instruction Manual

7. PROGRAMMING

The RBC 8000 timer can be programmed to operate on any day(s) of the week, odd
days or even days. In cyclical mode the RBC can also operate from every 1 hour up to
every 12 hours or from once a day up to every 30 days. The RBC has four start times
per day and durations from 1 minute up to 5 hours and 59 minutes.
This section explains the programming features, and the steps necessary to assign
irrigation schedules. To program the timer use the
programming mode, the
change the value.
NOTE: Only a flashing value can be changed.
NOTE: If the last data entered stops flashing, press
programming and repeat the steps.

8. SETTING CURRENT TIME AND DATE

The timer can display the time in either a 12 or 24 hour format.
To change the time format, from the home screen:
1. Press the
(AM/PM disappears).
SETTING THE CURRENT TIME AND DATE
To enable the timer to operate properly, the current time and date must
be set.
1. Press the
of the week.
to make the entry flash and the
button for three seconds until the
button, until the
display switches format
icon appears along with the time and the day
5
to select the desired
buttons to
again to resume