Sharp CS-4194H Service Manual page 6

(5) Insulation sheet (Small) attachment
Attach the insulation sheet (Small) to insulate the printer motor wiring.
Insulation sheet (Small)
old the insulation sheet (Small) to
secure the printer motor wiring.
Attach the insulation sheet (Small) to
prevent the printer motor wiring from
being damaged by the solder section
on the back of the printer PWB.
(6) Wiring of the secondary side of the transformer
Pass the lead wire of the secondary side of the transformer through the
slit section of the rib on the upper cabinet, and attach UL tape to the slit
section to fix the lead wire.
Atta
lead w e
UL tape
Insulation sheet (Small)
printer motor wiring
UL tape t keep t e
de t e g ve.
Lead w e
e t t e ppe a et
CS-4194H Servicing
(7) Protection tube
(7)-1. CS-4194H (AAC, ACO)
Insulate between the transformer and the AC cord connector with pro-
tection tubes (2 pcs 2 positions).
Protection tube (2 pcs)
Protection
tube (2 pcs)
(7)-2. CS-4194H (TRC)
The CS-4194H (TRC) uses 14 protection tubes in total (that is, 2 pcs
positions) as shown above.
[VOLTAGE SELECTOR]
Protection tube
(Heat contraction tube)
2 pcs/position
5 positions
[FUSE HOLDER]
Protection tube
(2 pcs)
Protection tube
(2 pcs)
– 6 –
Transformer
Protection tube
(One: Outside)
Protection tube
(One: Inside)
Use two protection tubes at
every one position.
Fuse
holder
7